• Calibrate a FACTS Touchscreen

    Control 09.04.2008 No Comments
    Via TouchscreenImage
    (2001FS system)

    If the touchscreen is working well enough to navigate through the SubMenu, the calibration can be initiated here. If not, skip down below to see Keyboard instructions.

    2. Select Submenu 1
    3. Select System Service Menu
    4. Enter password if needed.
    5. Select Touch Screen Calibration

    Read more…

    Tags: ,

  • On-Cal Gauge Calibration Procedure

    Control 09.04.2008 No Comments
    (For a more detailed Calibration Procedure please refer to Chapter 14 of the FACTS 2001FS Manual.)
    1. Clean all debris from the Roller assembly wheels.
    2. Clean all debris from the Gauging roll surface.
    3. Put the gauges down on a bare roll.

    Read more…

    Tags: , , , ,

About Us

Visit the main FACTS website or call us at 330.928.2332 to learn about our wide breadth of gauging, control, and information system offerings.

Keyword Search

actuator architecture back lash bearing calender calibrate cord Cord Placement Eccentricity Extrusion fabric force gauge grind information Mill Feed ON-CAL ON-CAL3 operator rate of change Roll roll surface temperature run-out scanner speed Spots stopped touch screen warm-up water water passage

Categories

Recent Posts

Similar Posts

Subscribe

Latest Posts from our Tech Blog

Subscribe to our Content on your Start Page (RSS).
or
Be alerted to new posts on this site via email.

Recent Comments

Global Site Hits

Locations of visitors to this page