Download the Total Calender Line Control Solutions Brochure for a run down of our complete solution set for calender gauging, control, line control, and other hardware/gauging options.

• Calender Gauge Control System
• ON-Cal 3 Gum wall thickness measurement - ON Calender
• Dynamic Target Optimization 
• Cord Spacing Vision System
• Wire Balance Gauge
• Calendered Width Measurement
• Bubble Piercer (Blister Breaker)
• Total Line Control System
• Total Information Management

The FACTS TCC 1600FS Total Calender Control System is designed specifically with "on calender" fixed sensor measurements for machine direction and cross direction control of the calender process. 

The FACTS Inc. calender gauge control system brings fast precise control to individual gums, getting within gum walls thickness tolerance in less than 1 calender roll revolution after a specification change or start-up!

 

ON-CAL Gauges

Download Datasheet

The FACTS ON-CAL 3 is a precision gauge for the measurement of nonmetallic calendered materials, such as rubber, vinyl and other plastic materials. It is a non-nuclear, contact measurement gauge that incorporates automatic zero calibration to maintain high accuracy.  No electronics are used on the calender on this simple, robust design.  Being so close to the calender nip, ON-CAL gauges reduce transport lag, thus providing a fast response.

The FACTS Inc. calender gauge control system typically brings the individual gum wall gauges within specified thickness tolerance in les than 1 calender roll revoution after a specification change or start-up!

• Fast due to very short transport delay and no scanning delay
• Accurate and easy to maintain
• Inherently safe – no nuclear source or radiation

Dynamic Target Optimization            

Download Datasheet

The FACTSCalendering Gauge Control System is able to reduce the standard deviation of profile thickness or gauge distribution on calenders.  Reducing the SD allows for tigher control of your ouput, allowing your targets to shift closer to your minimum thickness requirements.  See the brief graphical explanation here.

Cord Spacing Vision System

Download Datasheet

The FACTS vision system which has been designed to detect missing cords as well as provide complete cord spacing measurement.  Optional post calender marking of defect location is available on calender.  The System provides continuous measurement and monitoring of:

• Cord count /spacing
• Crossed, Paired, or Missing Cords
• Measures the entire web width multiple times per second – this is a fraction of the time required by nuclear scanning systems
• Optional continuous marking system of defect location
• Machine direction with transport compensation
• Cross sheet position

Wire Balance Gauge

Scanning precision measurement of wire placement within assembled calendered wire fabric - non-contact, non-nuclear.  Contact us directly to discuss your specific application.

Calendered Width Measurement

FACTS Inc. can assist our customers with width gauging systems at any point on a calandering line.  Contact us directly to discuss your specific application.

• Pre-Calender
• Post Calender
• Windup
• High Relability LED Illumination

Bubble Piercer (Blister Breaker)

FACTS Inc. can provide a complete mechanical knife system to minimize bubbles (blisters) on the calender.  Contact us directly to discuss your specific application.

• Low-Profile
• Mechanically Compatible with FACTS On-Cal 3 gauges
• Mimimal gum distortion
• Traversing castering knife is speed synchronized with calender speed.

TCC 1600 Total Line Control System

• Control of the complete calender line

• Drive co-ordination

• Tension control
• Roll temperature control

• Line logic control from let-off thru Wind-up

• Integrated with gauge control system

 

Calender Gauge Control Tips               

 

  Download the original Tips whitepaper here.